Automatic screwing machine The use in industry is more and more extensive and frequent, and the two most easily overlooked problems and maintenance of automatic screwing machine do you know? Today, Yinghe Xiaobian will tell you something about it.
1. Automatic screw machine from the design and principle of it, itself speaking, it does not have any big shortcomings, but a lot of times we will ignore a problem, is the quality of screws! Domestic screw manufacturers produce defective screws relatively more than foreign countries, such as big head, flat head, batch front is Automatic screw locking machine It is fatal to automatic screwing machine, so it is worth our careful consideration when choosing screws.
2. First of all, we should be clear about the causes of screw slippage. The main reasons are machine jam, sliding teeth (not tightly locked) and flower heads, which are caused by poor quality screws. Or is the manufacturer to solve the screw quality is not good and change the design size caused by, for most screw machine manufacturers is unable to solve, is a fatal disease!!! In addition, there are problems with the machine itself, such as the materials used, the technology used and the brand of electronic parts. However, these are not very big problems, because powerful manufacturers can solve this problem. Card machine is caused by defective screws, and the so-called sliding teeth, flower head, there are two reasons. The first is the structural problem of its own design. The second is that the screw machine manufacturer has enlarged the channels of all screwing machines to solve the above-mentioned special-shaped screws, including the electric nose nose mouth. Too large inner diameter of the electric nose mouth is the biggest reason for floating teeth and flower heads!
How to extend the life of the automatic screwing machine after we buy it? Here are some simple cleaning and maintenance methods:
Any machine and equipment, it needs to be cleaned and maintained regularly. If the time is long, the machine and equipment are easy to break down, and the service life will be greatly shortened. Therefore, when using the automatic locking screw machine, it also needs daily cleaning and maintenance. The specific operation method is as follows: if it is not used for a long time, please turn off the power supply. Conduct periodic ventilation and check the performance. Periodically clean the outer surface of the case of the automatic screwing machine. If do not use for a long time, as far as possible to use the cloth with oil to wipe, as little as possible with water. Periodically clean the screw track to ensure that the screw is smooth in the track. The screw silo is cleaned periodically, and the residue in the silo is usually blown out by high pressure gas. Clean the feeding system periodically to ensure the smooth feeding system. It is recommended to add some grease to the moving part. Keep the automatic screwing machine ventilated and dry. Check frequently. If you have any use problems or need maintenance, please contact the manufacturer in time. Do not disassemble or disassemble by yourself.
If you are right, I won't say much about it Automatic screwing machine There are questions do not understand, you can call us to consult oh.